Abstract
Nanocomposite dielectrics are an increasingly important area of innovation in capacitor research as an avenue to
improve capacitive energy density, electrical breakdown strength, and temperature stability of devices. In such
devices, morphology control is critical in order to optimise electrical field distribution in the device and to
prevent the clustering of nanoparticles lowering breakdown voltages. However, this is difficult to achieve with
large-scale fabrication techniques, such as melt extrusion and stretching, as melt processing can induce clustering
and offers few possibilities for fine structure control of length scales below 1 μm. Layer-by-layer fabrication offers
a potential bottom-up alternative whereby dielectrics are printed by successive depositions of ultra-thin layers of
a room-temperature-stable polymer ink. This would allow fine thickness and morphology control and could
easily be adapted to industrial-scale printing techniques, like roll-to-roll slot-die coating. This study explores this
technique by developing polypropylene-based inks in industry-friendly solvents that are then used to fabricate
capacitor devices. A gel ink was able to be used to deposit ultrathin (sub-200 nm) layers of mostly amorphous
polypropylene with high reproducibility. Capacitors based on these polypropylene layers perform commensurate
with commercial devices, exhibiting excellent self-clearing and breakdown performance. Successive depositions
of the ink were also demonstrated, allowing the fabrication of devices with finely tuned thicknesses and ca-
pacitances, as well as nanocomposite capacitors. This demonstrates the viability of layer-by-layer dielectric
printing at large scale and paves the way for commercial ultra-thin conformable polypropylene capacitors, multi-
component sandwich nanocomposite capacitors, and multilayer polypropylene capacitors, as well as brand new
possibilities in dielectrics research.
improve capacitive energy density, electrical breakdown strength, and temperature stability of devices. In such
devices, morphology control is critical in order to optimise electrical field distribution in the device and to
prevent the clustering of nanoparticles lowering breakdown voltages. However, this is difficult to achieve with
large-scale fabrication techniques, such as melt extrusion and stretching, as melt processing can induce clustering
and offers few possibilities for fine structure control of length scales below 1 μm. Layer-by-layer fabrication offers
a potential bottom-up alternative whereby dielectrics are printed by successive depositions of ultra-thin layers of
a room-temperature-stable polymer ink. This would allow fine thickness and morphology control and could
easily be adapted to industrial-scale printing techniques, like roll-to-roll slot-die coating. This study explores this
technique by developing polypropylene-based inks in industry-friendly solvents that are then used to fabricate
capacitor devices. A gel ink was able to be used to deposit ultrathin (sub-200 nm) layers of mostly amorphous
polypropylene with high reproducibility. Capacitors based on these polypropylene layers perform commensurate
with commercial devices, exhibiting excellent self-clearing and breakdown performance. Successive depositions
of the ink were also demonstrated, allowing the fabrication of devices with finely tuned thicknesses and ca-
pacitances, as well as nanocomposite capacitors. This demonstrates the viability of layer-by-layer dielectric
printing at large scale and paves the way for commercial ultra-thin conformable polypropylene capacitors, multi-
component sandwich nanocomposite capacitors, and multilayer polypropylene capacitors, as well as brand new
possibilities in dielectrics research.
| Original language | English |
|---|---|
| Article number | 100025 |
| Journal | Power Electronic Devices and Components |
| Volume | 4 |
| Number of pages | 10 |
| ISSN | 2772-3704 |
| DOIs | |
| Publication status | Published - 30. Oct 2022 |